تبلیغات
برق قدرت - Loudspeaker Thump Eliminator
 
برق قدرت
کلیه حقوق متعلق به وبلاگ برق - فیزیک می باشد و کپی برداری از مطالب در وبلاگ ها و وب سایت های دیگر فقط با ذکر منبع مجاز می باشد .
درباره وبلاگ



مدیر وبلاگ : حامد ص
نویسندگان
نظرسنجی
نظرتون راجع به مطالب وبلاگ چیست؟ کجاااااا کجاااا نمیری یه وقت ؟! نظر بده ببینم







پنجشنبه 12 بهمن 1391 :: نویسنده : حامد ص

3 - 5 seconds delay time  10 to 48V ac supply

Circuit diagram:...

Loudspeaker Thump Eliminator

Parts:

R1_______________1K  1/4W Resistor (Optional, see text)
R2_____________100K  1/4W Resistor
R3_____________470K  1/4W Resistor

C1______________47µF  50V Electrolytic Capacitor
C2_____________100µF  25V Electrolytic Capacitor

D1,D2_________1N4002 200V 1A Diodes

Q1,Q2__________BC337  45V 800mA NPN Transistors (See Notes)

RL1____________Relay with DPST switch. Coil voltage
               according to available power supply voltage (See text)

SW1_____________SPST Toggle or slide switch (Optional, see text)

Comments:

Some solid state power amplifiers make a loud thump when turned on or off.
The thump you hear when you turn on or turn off your amplifier is caused by the sudden application or interruption in supply voltages to the amplifier output stages.
To remove the thump, the output signal must be delayed (and thus the transient) until the output voltage will reach a safe level for the speakers.

Circuit operation:

In the circuit diagram, resistor R3 and capacitor C2 form an RC network timer. When voltage is applied to the circuit, R3 allows C2 to charge to about 1.2V. The transistors Q1 and Q2 are connected in a Darlington configuration and are then non-conducting until the charge across C2 does not exceed the sum of the base-emitter voltage of Q1 and Q2, i.e. 0.6V for each transistor for a total of 1.2V. Once the voltage across C2 exceeds 1.2V, Q1 and Q2 immediately run into saturation, activating the relay RL1, which completes the circuit between the amplifier and speaker systems.
The power supply circuit consists of a simple rectifier diode and a low value filter capacitor (D1 and C1). The ac voltage required is taken from the secondary winding of the transformer available in your amplifier.

In many cases, when dual supply is present and therefore the secondary winding is center tapped, the circuit can be connected across the central tap and one of the two outer leads of the winding or, on the contrary, across the whole winding. In the latter case, the available voltage will be twice the first case.
This choice will affect also the coil operating voltage of the relay used. You can choose a relay having a coil rated at 12V dc for a secondary winding ac voltage up to 15V; a 24V relay for an ac voltage up to 30V (or two SPST 12V relays wired in series, one for each channel). For higher ac voltages use a 48V relay or two SPST 24V relays wired in series.

SW1 and R1 provide an optional mute facility: closing SW1 the Relay will go off and therefore the amplifier will be muted.

Notes:

  • After turn on, the relay will be activated with a delay of about 3 - 5 seconds. The delay time can vary by changing the values of R3 and/or C2.
  • If you do not want the mute function, SW1 and R1 can be omitted.
  • If two relays wired in series are employed, the added relay must have its own clamping diode connected across the coil.
  • When a voltage supply of about 48V is used, substitute BC337 transistors with BC546 types.




نوع مطلب :
برچسب ها :
لینک های مرتبط :
یکشنبه 15 مرداد 1396 01:16 ب.ظ
I simply could not leave your website before suggesting that I really enjoyed the usual info a person supply on your guests?
Is going to be back continuously to investigate cross-check
new posts
یکشنبه 11 تیر 1396 02:39 ب.ظ
Hi there very nice website!! Man .. Excellent ..
Superb .. I will bookmark your website and take the feeds also?
I am happy to seek out so many helpful information here within the submit, we need develop more strategies on this regard, thanks
for sharing. . . . . .
سه شنبه 2 خرداد 1396 03:10 ب.ظ
What i do not understood is if truth be told
how you are no longer really much more neatly-liked than you might
be now. You're very intelligent. You recognize therefore significantly in the
case of this subject, made me personally imagine it from numerous numerous angles.
Its like women and men aren't involved unless it's something to accomplish with Lady gaga!
Your personal stuffs nice. All the time deal with it up!
 
لبخندناراحتچشمک
نیشخندبغلسوال
قلبخجالتزبان
ماچتعجبعصبانی
عینکشیطانگریه
خندهقهقههخداحافظ
سبزقهرهورا
دستگلتفکر


آمار وبلاگ
  • کل بازدید :
  • بازدید امروز :
  • بازدید دیروز :
  • بازدید این ماه :
  • بازدید ماه قبل :
  • تعداد نویسندگان :
  • تعداد کل پست ها :
  • آخرین بازدید :
  • آخرین بروز رسانی :